A powerful architecture & Construction theme. Construct your website in the perfect Ratio.
Alienum phaedrum torquatos nec eu, vis detraxit periculis ex, nihil expetendis in mei. Mei an pericula
Call us+251 938 888888
Mon - Sat 8:30AM-5:30PM Sunday closed
Eri Bekentu, Piassa, Addis Ababa


Comforto Submersible Water Pump FL

Submersible electropumps

Motor Power in 300Hp ,

Single and Three Phase


USES: The FL serie of two-pole submersible electropumps is widely used in handcrafts and industry to dispose of clean or slightly dirty water or other liquids. They are
suitable for lifting fl uids from tanks or storage traps for rainwater, cellars, for drying underpasses or other uses. It is strictly prohibited to use the electropump for lifting
combustible fl uids. It is also prohibited to position or to remove the pump by the electric cable.
Maximum temperature of the pumped fl uids: – Continuous duty: 60°C; – Intermittent duty: 90°C.
Minimum pumping level: 10 cm. above the pump body. Maximum fl uid density: not higher than 1.100 Kg/m3. The electropumps can pump fl uids containing solids with a
diameter that allows them to pass the impeller (see the technical chart).
CONSTRUCTION: The components have been accurately selected in order to achieve maximum reliability and long life even in the hardest applications. The materials of
which the electropump is made are: G20 cast iron (motor cover, motor casing, pump body, impeller), stainless steel AISI 420 (motor shaft), stainless steel screws, while the
gaskets are made of nitrile rubber (oil-resistant). The bearings are of high quality and need only be greased after a long period of operation. Mechanical seal made of silicon
carbide/alumina. The top seal has a lip (oil seal).
ELECTRIC MOTOR: The two-pole electric motor, single-phase or three-phase has a die-cast aluminium rotor, immersed in a dielectric anti-oxide oil bath. The power available
ranges from 0,37 kW to 2,2 kW. Single-phase voltage of 230-240 V. 50 Hz and a three-phase voltage of 230/400 V. 50 Hz. The motors have been designed to give maximum rated
power with a variation of +/- 5% of the rated frequency or voltage. They are completely watertight, insulation class F, degree of protection IP 68. The single-phase motors are fi tted
with thermostat-controlled safety microswitches to avoid undesirable damages to the motor in the event of blocking of the impeller. The temperature of the thermostat-controlled
microswitches is set at 130°C. The motor is cooled by the same fl uid in which the electropump is immersed. The standard equipment includes 10 metres of cable H 07 RN-F and
a Schuko plug (attention: 5 mt. of cable H 07 RN-F in the model FL 50/32), while three-phase versions are supplied with free terminals. The user must provide protection for threephase
electropumps. For the power from 0,9 kW to 2,2 kW, the connection for the capacitor comes executed to the outside through appropriate cassette to watertight estate.